Re: [A/S] Funtioning Power On Light with non Univolt converter

["Christopher45103" <blickcd@xxxxxxx>]

My Univolt was also replaced with an aftermarket charger/converter 
and the AC Power indicator won't light up on my monitor panel.

I've seen the unconnected wire in the 12 volt fuse panel which 
supposedly goes to the indicator light.  If I understand the previous 
post correctly, if I put a jumper wire from that terminal to ground, 
the indicator will light up.  What convenient ground point did you 
use?

BTW, I understand how to hook up the Radio Shack relay so no further 
explanation is needed.  Also, I have a '79 International 31' center 
bath.  The charger, 12 volt panel and batteries are all up front 
below the front window, but I assume the wiring configuration is 
similar to yours.

Christopher