Re: [A/S] No water

[Thomas LaVergne <thomaslavergne@xxxxxxxxx>]

Only in the fact that I am familiar with rear bath models.  You have a 
blockage somewhere, it is most likely the pressure regulator or as Daisy 
mentioned the valves are shut off.  Go to the rear of the trailer and open 
the big long compartment that is above the bumper.  This will expose your 
plumbing.  Once opened you should see the pressure regulator on the left as 
well as a couple of water spigots (valves).  Make sure the spigots are 
opened.  I don't have my manual in front of me to check the drawing but I 
believe 2 spigots control hot and cold to the trailer and the other 2 
control drain hoses out from under the trailer to drain the lines with...the 
last two you will want to close again if you get the water running.  If it 
starts running then, of course, that was the problem.  It is also possible, 
as someone already mentioned, that the screens in the faucetts are plugged, 
although you would think that at least some water would run out of one of 
them.  If all of the water was being diverted due to the split copper pipes 
you would see and hear water running all over the place.  Check those water 
spigots.  Has anyone ever had a completely pugged pressure regulator?  I 
think they can be taken apart and cleaned out.

Thomas