Re: [A/S] Corroded door handle 74 International

[Roger Hightower <n7kt@xxxxxxxxxxxxxxxx>]

John,

That looks to be the same door lock assembly as the '75, and here's what
the service manual says about removing the handle assembly:

1.  Remove inside door lock handle by loosening set screw and pulling
handle from shaft.

2.  Remove screw from door frame, securing lock to the frame.  This is
located just above the door.

3.  Remove three mounting screws that attach inside skin to lock body.

4.  Use a drill (No. 30) and remove rivets from center seam of inside
door skin; also from edge of door approximately 12" in each direction.

5.  Pull inside skin slightly to clear inside lock handle shaft.

6.  Lock can now be removed.

7.  Replace by reversing above steps.

Good luck.  Doesn't seem to be too hard.


-- 
Roger Hightower
1975 31' Sovereign....WBCCI 4165....VAC
mailto:n7kt@worldnet.att.net